Slips trips and falls

Slips trips and fallsSlips trips and falls are estimated to cost business over £300 million pounds a year. They are rarely fatal but cause a lot of pain, discomfort and time off work. Slips trips and falls are also important in relation to the Manual Handling Regulations.

A slip, trip or fall can occur at any time and often when your least expecting it. You could be walking around the workplace, carrying a load or simply getting up from your desk and a fall could occur.

Through risk assessing and health and safety inspections will identify many hazards but good health and safety awareness in the workplace by employees will also reduce the hazards.

Some examples of slip, trip and fall hazards include:

Wet floors as water are often invisible and cause a slip hazard. Control is by cleaning up water and the use of warning signs.

Kurbs and steps are an oblivious hazard but floor mats can easily trip people up.

Other trip hazards include boxes, handbags, rubbish, photocopier paper to name a few.

Electrical cables pose a double risk. First, the trip hazard and secondly if cables are pulled from the wall then there is an electric shock risk.

Good housekeeping will reduce many slip, trip and fall risks. Some examples include:

  • Tie up cables, check under desks to ensure electrical safety at work
  • Handbags and laptop bags need to be put in draws or stored safely.
  • Avoid leaving coats on the back of chairs as they get caught on the wheels and can cause you to fall
  • Photocopy paper left on the floor
  • Underfloor cable points
  • Door stops could cause a trip hazard
  • Coats on the back of chairs pose a risk of jamming the chair and causing you to fall
  • Stairs are an oblivious place where people can fall. Keeping the stairs free if obstacles and always holding the handrail will reduce the risk of accidents
  • Check carpets for loose areas and report immediately so they can be fixed.
  • Think about your actions, tidy up after yourself, report any concerns and if you are caring or moving a load, check your route first.

To reduce the risks of injury you need to ensure effective control measures are in place.

Comments

  1. Pingback: Electrical safety at work - Health & Safety Wiki

  2. Pingback: Warning signs are a standard design and the HSE have made a standard sign

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.